This site is educational purpose only, before taking any actions based upon such information, we encourage you to consult with the appropriate professionals.
I got this error: 'docker: Error response from daemon: Could not attach to network <nw-name>: rpc error: code = 7 desc = network <nw-name> not manually attachable.' when i try to create the container on the overlay network on swarm mode enabled, In docker 1.12 with swarm mode enabled, "Swarm" scoped networks (see the "SCOPE" column) cannot be used for docker run, only for services and now it has been rectified. I'm using updated version of docker, but still why i'm experiencing the error ? because the network just created but not manually attachable. To fix the issue we gonna use --attachable flag while creating network. [ --attachable Enable manual container attachment ] (Need to create service on the overlay network, so that the overlay network will available / list on the worker node) docker inspect attnw (attnw is our test network)should show your own c
Error while cPanel installation: (ERROR): - ssystem [EXIT_CODE] '/usr/bin/yum' exited with 1 (ignored) (DEBUG): - ssystem [END] (FATAL): yum failed 6 times. Cannot continue! fix: It looks like you have some name resolution issues on the server. Just run the following commands on your server and it will resolve the name resolution issues. #echo "nameserver 8.8.8.8" >> /etc/resolv.conf #echo "nameserver 8.8.4.4" >> /etc/resolv.conf if it is not working properly still facing same error, then here we go, # rpm -e --nodeps bind-chroot # rpm -e --nodeps bind # yum install bind
Don't Panic, This normally occurs when a client decides to reduce its TCP window size, without the server expecting it. This can be the case when fragmentation is an issue, or when the client is using an embedded device with very little NIC buffer memory. This is a completely normal behaviour, and you’re likely to see quite a few such packets in your log. The messages are informational only, and are used to debug networking issues. I’d be worried if you saw hundreds of thousands of these packets, since there are attacks that involve packet fragmentation and small window sizes, but otherwise it’s just the normal sort of noise you should expect to see on any internet-facing network. In fact, the “repaired” part of your message is showing that your network driver fixed the issue, which is usually done by concatenating the payloads of two fragmented packets together. Shouldn’t be an issue at all. … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … …
Comments